Advanced MXS-504 MxPro 5 Series Display Card | For MX-5000 Control Panels
£443.76 (inc VAT: £532.51)
Key features
- Fits MX-5100, MX-5200 and MX-5400 basecards
- Replace display without swapping basecard
- Single spare part covers whole MxPro 5 range
Downloads
Summary
The Advanced MXS-504 is a spare liquid crystal display (LCD) card for the MxPro 5 series of fire control panels, and the one thing that sets it apart is its reach: it fits the MX-5100, MX-5200 and MX-5400 basecards, so a single part covers the whole panel range rather than one display per panel size.
View full overview Show less
That matters when you’re stocking spares for a multi-site contract or responding to a fault call. Carrying one display card instead of three cuts down what you need in the van and speeds up a repair visit, because you don’t need to know the exact panel variant before you set off.
On site, the card plugs into the basecard in place of the faulty display, restoring the panel’s local indication and keypad interface without you having to replace the whole basecard or disturb the loop wiring; if the basecard itself needs replacing rather than just the display, the MXS-501-CP-S and MXS-503-CP cover that job.
Features
- Fits MX-5100, MX-5200 and MX-5400 – one spare covers the whole MxPro 5 basecard range, so you don’t need to match stock to panel size
- Display-only replacement – swap out a faulty screen without pulling the entire basecard, keeping downtime to a minimum
- Drop-in spare – designed as a direct replacement part for existing MxPro 5 panels already on site
Specifications
| Sku | MXS-504 |
|---|---|
| Product Type | Spare LCD display card |
| Compatible Panels | MX-5100, MX-5200, MX-5400 (MxPro 5 series) |
| Part Category | Control panel spare PCB |
FAQ
Yes, the MXS-504 is listed as the spare display card for all three basecards (MX-5100, MX-5200, MX-5400), so one part covers the whole MxPro 5 range rather than being size-specific. The display card is separate from the basecard and loop circuitry, so fitting it shouldn’t alter existing programming or loop configuration. The datasheet doesn’t detail the fitting procedure in full, so confirm all settings are retained once the new card is installed. Advanced lists separate spares for rack mount (MX-5000R) units, so check the specific part number with Advanced’s documentation or with Huvo before ordering if you’re working on a rack mount installation. Swapping a display card is a like-for-like replacement rather than an extension or modification to the detection system, so a full re-verification under BS 5839-1 shouldn’t normally be required. It’s still good practice to confirm panel operation and any affected indications before signing the work off, and to check site-specific requirements with the responsible person. At minimum, record the work carried out, the part fitted (MXS-504), and confirmation that the panel’s programming and functions were checked and unaffected. The datasheet doesn’t specify documentation requirements for this spare, so follow your normal service log and BS 5839-1 handover practice.Will the MXS-504 fit my existing MX-5100, MX-5200 or MX-5400 panel?
Does replacing the display card affect panel programming or loop devices?
Is this suitable for MX-5000R rack mount panels?
Do I need to re-verify the whole system under BS 5839-1 after fitting a new display card, or just check this one part?
What should I hand over to the responsible person after replacing the display card?
Downloads
- Datasheet (Adobe PDF)
Additional information
| Device Type |
|---|
