Advanced

• Polycarbonate enclosures for EvacGo modules
• 170x210x66mm

• Easy to use
• Clear device display
• Auto shut-off

• Spare key For MxPro5 panel access enable keyswitch 

• Use with MxPro 5 analogue addressable panels
• MXP-568 compatible with Apollo, Hochiki, and Argus Vega protocols
• MXP-567 compatible with Nittan protocol

• Each output individually programmable.
• Cost effective against ancillary hardware.
• Each output 30V AC/DC, 1 Amp rating.

• Suitable for use with a wide range of control equipment.
• 12V supply (1.5A only)
• High efficiency switched mode power supplies.

• Spare door key for Advanced control panels.

• Used to connect local peripheral equipment to GO1 panels.
• PBUS modules must be configured using the PC Tool.

• Replacement access enabled key switch assembly for Advanced GO1 panels.

• Dual protocol support for Apollo Discovery/XP95 and Hochiki ESP detector systems
• 500mA maximum current capacity per loop during alarm conditions
• Designed for MxPro 4 analogue addressable fire alarm panels

Enter a brief description of your product here. This description will be displayed on product list pages.

• RS232 9-way to 3-way connector
• MxPro 4 & 5 panel compatibility
• Serial upload/download functionality

• Semi-flushing bezel for MxPro 5 remote terminal displays
• Supplied with fitting kit for a quick and easy solution

• Two fire routing outputs.
• Outputs are monitored for open and short circuit wiring issues.

• Provides remote access to devices on an Ad Net network..
• Configurable event email notification.
• Compatiable with both Mx-5000 & Mx-4000 series fire panels.
• Available as PCB only or boxed in enclopsure.
• Option of standard or fault-tolerant networks.

• Enable/disable controls.
• Group isolate to disable I/O across network.
• For use to start/enable a class change.

• Complete false alarm management with verification and investigation delays
• AlarmCalm button module for manual acknowledgement by occupants
• Compatible with MxPro 5, Go, Axis EN and AxisGo fire panel ranges

• Designed for IP30 protection.
• AC terminal block and leads.
• Internal labelling.
• Hinge pins.

• Enable/disable controls.
• Group isolate to disable I/O across network.
• For use to start/enable a class change.
• Trapped and un-trapped key switches available.
• Control of multi-sensor/device sensitivity mode change.
• Simple to install and configure.

• True Peer to Peer
• Up to 1.5Km between Control Panels
• Windows based PC Set Up
• Network Analysis

• Advanced MXS-505 Spare Key For Glazed Doors.

• Retrieval of analogue values, panel meter readings and event logs from the Mx control panels.

Enter a brief description of your product here. This description will be displayed on product list pages.

• This product is obsolete and has been replaced by the Advanced MxPro5 Next-Generation Loop Driver Card
• Loop card to expand the capacity of a MxPro 5 panel
• Version available which supports the Apollo, Hochiki & Argus Vega protocols or the Nittan protocol