Shopping Basket

0 Items

Subtotal £0.00

Solo Smoke Detector Testing

Smoke Detector Testing Products
Smoke Detector Testing Is Quick And Easy With Solo

The Solo 330 lets you functionally test compatible smoke detectors on a fire alarm system by introducing test aerosol into the sensing chamber. This checks whether the detector responds to the test aerosol. For the wider system checks, follow the site’s test plan and the detector and panel manufacturers’ instructions.

What you need for a Solo 330 smoke detector test

  • Solo 330 or 332 aerosol dispenser. Choose Standard for the Solo 330. Detectortesters specifies the 330 for detectors up to 100 mm in diameter. Check that the cup fits over your detector. The Solo 332 is the larger-cup option.
  • A compatible Solo access pole and a smoke test aerosol approved for the detector. Solo A5 is a 250 ml flammable aerosol designed for dispenser use. Check the can label, safety data sheet and site restrictions before use.

How to test a smoke detector with the Solo 330

Before starting, notify the people responsible for the system and follow the site’s test procedure. Use panel test mode or the agreed precautions to prevent unwanted alarms. If the system is remotely monitored, follow the agreed procedure with the alarm receiving centre.

  1. Fit the compatible aerosol in the red retaining cup and adjust it as shown in the Detectortesters quick-start guide.
  2. Fit the dispenser to the Solo pole and raise the clear cup over the detector. Push up gently for no more than one second to release a short burst.
  3. Keep the cup in place. If needed, repeat at ten-second intervals until the detector activates, up to one minute in total. When the detector responds, lower the cup to let the aerosol disperse. If it does not respond within that limit, record the result and have the detector investigated under the site’s maintenance procedure.
  4. Record the result and confirm the expected panel indication where required by the test plan. Once testing is complete, restore normal operation, including any signalling or functions affected by the test, and tell the relevant people the system is back in service.

What replaced Solo A3 smoke detector test spray?

Detectortesters discontinued Solo A3. In its A3 phase-out notice, the manufacturer identified A5 as a flammable option and A10 as a non-flammable option. If your site or detector requires a non-flammable aerosol, check the current suitable product with the manufacturer before ordering.

For poles, dispensers and kits, browse Huvo’s detector test equipment.

Trade
Account
Enquiry?